Return to RC101410 One Way Needle Bearing/Clutch 5/8"x7/8"x5/8" inch
Sort By::
Page of 1


  0 of 0 people found the following review helpful:
 
5 of 5 Great site. Great bearings for my purpose April 22, 2021
Reviewer: Bud from Fort Mill, SC United States  
I converted a crank handle on a honey bee extractor to use my drill. Works great.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 RC101410 one way bearing clutch November 2, 2016
Reviewer: Anonymous Person from Dennis, MA United States  
Good product that fit Hahn Eclipse rear wheels exactly. Original Hahn number 311258 on the one way bearing clutch part (2) per wheel. Take extra care in testing the correct rotation before tapping into the wheel cylinder.
Delivery was on time.











rotation before
tapping into the wheel shaft

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Does the job and price is right . August 9, 2015
Reviewer: Honey Guy  
installed in the center of my hand crank that turns a honey extractor. Now when I let go the handel  it just hangs in a safe manner well the basket still spins..

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Accurate ID fit October 18, 2013
Reviewer: Pete  
Used this bearing in a sprag clutch for my sailplane winch.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Will buy again July 11, 2012
Reviewer: RH from MD  
Great product  great price.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 A quality produce at an excellent price December 26, 2011
Reviewer: NPCRR from the Northwest  
Excellent product at 2 3 the price of other suppliers

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Great service August 13, 2011
Reviewer: farmer  
As advertised

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
3 of 5 Not an exact replacement. June 16, 2011
Reviewer: Lawnmowerman from Cranberry Twp, PA  
I was replacing a part on a lawnmower self propel drive with the same part number and dimensions. The two parts appeared identical but the new RC101410 required a shim to fit into the hub that original was pressed into.  Once shimmed into the hub tightly  the clutch worked perfectly.

Was this review helpful to you?