Home > Metric Bearings > 20mm inner diameter Bearings >

7004CYDUP4 Nachi Angular Contact Bearing 20x42x12 Abec-7 Bearings
7004CYDUP4 Nachi Angular Contact Bearing 20x42x12 Abec-7 Bearings


 
Our Price: $245.37
. Item: 7004CYDUP4 Nachi Ball Bearings
. Type: Nachi Angular Ball Bearings
. Cage: Polyamide resin cage
. Quality: ABEC-7 (P4 quality)
. Dimensions: 20mm x 42mm x 12mm/Metric

Product Code: KIT10871
Qty:

Description
 
High Precision Ball Bearings
7004CYDUP4 Nachi Angular Ball Bearings
15 degrees Contact Angle
Abec-7
20mm x 42mm x 12mm
Made in Japan


7004CYDUP4

7004CYDUP4 Nachi high precision Angular pair of Ball Bearings with 15 degrees contact angle and Polyamide resin cage, pair of ball bearings is 2 duplex bearings, bearings are ABEC-7 (P4) quality and made in Japan.

  • Item: 7004CYDUP4 Nachi Ball Bearings
  • Type: Nachi Angular Ball Bearings
  • Cage: Polyamide resin cage
  • Quality: ABEC-7 (P4 quality)
  • Dimensions: 20mm x 42mm x 12mm/Metric
  • ID (inner diameter)/Bore: 20mm
  • OD (outer diameter): 42mm
  • Width/Height/thickness: 12mm
  • Size: 20 x 42 x 12 mm
  • Quantity: Pair of Bearings
  • Dynamic load rating Cr: 18,200 N
  • Static load rating Cor: 13,200 N
  • Limiting Speed:
    • Grease Lubrication: 21,000 RPM
    • Oil Lubrication: 28,000 RPM
  • Made in Japan


Dimensions
d D B r r1 a
20mm 42mm 12mm 0.6mm 0.3mm -2.4mm

Nachi Single Row Angular Contact Bearing

The raceways of both the inner and outer rings of this set up kind are made out of a set contact angle. These claws are non-separable. A larger quantity of balls may be installed than in the event of Deep-groove ball bearings, Because the balls are added using construction. Standard cage substances may be brushed steel, high-strength brass, or resin. Cage material is dependent on the bearing service or series and requirement. Single-row Angular Contact ball bearings can sustain loads, however, any axial load must be in 1 direction. This posture type is typically used to handle the triggered load caused by the internal force generated by the applied radial load. When mounting two single bearings in adjacent places, NACHI supplies these combination parts (pairs) with pre-adjusted clearance. Paired mix bearings are matched places. Combination or paired bearings could be ordered BACK-TO-BACK (DB), FACE-TO-FACE (DF), or in TANDEM (DT). DB or DF sets could maintain loads that are bidirectional.

Kit10871


Share your knowledge of this product. Be the first to write a review »