Nachi

7207CYP5 Nachi Angular Contact Bearing 35x72x17:Abec-5:Japan

$179.99
SKU: Kit10811
UPC: 00193019091111
Item: 7207CYP5 Angular Ball Bearings
Dimensions: 35*72*17 mm/Metric
ID (inner diameter)/Bore=35mm
OD (outer diameter D1)=72mm
Width/Height/thickness=17mm

Nachi Angular Ball Bearings
7207CYP5
35mm x 72mm x 17mm
15 Contact Angle
Polyamide resin cage
Abec-5
Made in Japan







7207CYP5 Nachi Angular Ball Bearings, 15 Contact Angle, Polyamide resin cage, Abec-5 Made in Japan, here are the dimensions of the 7207CYP5, the 7207CYP5 inner diameter is 35mm, the 7207CYP5 outer diameter is 72mm, 7207CYP5 width is 17mm.

  • Item: 7207CYP5 Angular Ball Bearings
  • Dimensions: 35*72*17 mm/Metric
  • ID (inner diameter)/Bore=35mm
  • OD (outer diameter D1)=72mm
  • Width/Height/thickness=17mm
  • 7207CYP5 Type: Nachi Angular Ball Bearings
  • Cage: Polyamide resin cage
  • Quality: ABEC-5
  • Basic Dynamic Load Cr (KN): 30.5
  • Size: 35mm x 72mm x 17mm
  • Made in Japan
  • Quantity: One Bearing 7207CYP5
d D B r r1 Basic Dynamic Load
35mm 72mm 17mm 1.1 0.6 30.5

The raceways of both the inner and outer rings of this bearing type are made with a set contact angle. These bearings are non-separable. Since the balls are inserted utilizing counter-bore construction, a larger number of balls can be installed than in the case of Deep-groove ball bearings. Standard cage materials may be pressed steel, high-strength brass, or synthetic resin. Cage material is dependent on the bearing series and or service condition. Single-row Angular Contact ball bearings can sustain radial, axial or composite loads, however, any axial load must be in one direction. This bearing type is generally used in pairs to handle the induced load resulting from the internal axial force generated by the applied radial load. When mounting two single bearings in adjacent positions, NACHI provides these combination parts (pairs) with preadjusted clearance. Paired combination bearings are matched sets. Combination or paired bearings can be arranged BACK-TO-BACK (DB), FACE-TOFACE (DF), or in TANDEM (DT). DB or DF sets can sustain bidirectional axial loads.