Nachi
6200-2NSE Nachi Bearing 10x30x9 Sealed C3 Japan
UPC: 00193019103340
Type: Nachi Deep groove Ball Bearing
Radial Clearance: C3
Closures: Double sealed rubber seals RS/RS1/2RS1
Dimensions: 10mm x 30mm x 9mm/Metric
6200-2NSE Nachi Bearing 10mm x 30mm x 9mm Made in Japan |
6200-2NSE Nachi Bearing, Made in Japan, the 6200-2NSE inner diameter is 10mm, the 6200-2NSE outer diameter is 30mm, 6200-2NSE width is 9mm.
|
Excellent Protection and Smooth Operation The combination of a unique lip design and seal groove provides a labrinth and steady seal contact.Breathing mechanism avoids torque increases caused byinternal pressure variation due to changes in operating temperatures.NSE seals allow NACHI bearings to have constant smooth operation and long service life. Rings and balls made of select material have superbly controlled accuracy such as roundness, contour,surface finish, and hardness to provide quieter operation, reduced vibration levels, and long life.Rivet-type pressed steel cages for strength and durability.High-performance grease for long life and low noise. |
This bearing is clearly a high quality component. It's well sealed, and it comes packaged well. So far the performance on my table saw armature has been good. I am confident this bearing will last for years in this application.
Product arrived promptly. Solved a problem with my Bosch table saw.
The bearings came in on time and I had to make a new hub out of high strength steel to accomidate the High Speed Dual Sided Garden Windmill with a 31" diamater. These bearings fit the new two sided shaft perfectly. This unit produces tremendous tourque under winds up to 40mph. In the past the factory bearings would not hold up and I had to rebuild the unit. Now it works perfect.
Porduct was as discribe and fit perfectly.
saw a review recommending this site because they had quality bearing replacements for my bosch table saw. turns out they were no more expensive than other suppliers.