VXB Ball Bearings

 





  Home > Mounted Bearings >

  1" Bearing UCP205-16 + Pillow Block Cast Housing Mounted Bearings
1" Bearing UCP205-16 + Pillow Block Cast Housing Mounted Bearings


 
Our Price: $9.37
. Item: UCP205-16 Bearing
. Type: Pillow Block Mounted Bearing
. Bolt Size: 3/8" inch
. Basic Dynamic Load (Cr): 14 KN
. Basic Static Load (Cor): 7.85 KN

Stock Status:In Stock
Product Code: KIT7369
Qty:

Description
 
UCP205-16 Pillow Block Bearing
Set Screw Type High-Center Height
1" inch Inner Diameter


1" inch UCP205-16 Pillow Block Bearing:vxb:Ball Bearing
1" inch UCP205-16 Pillow Block Bearing:vxb:Ball Bearing
1" inch UCP205-16 Pillow Block Bearing:vxb:Ball Bearing

UCP205-16 Pillow Block Bearing, UCP205-16 is Set Screw Type High-Center Height, Inner Diameter is 1" inch

  • Item: UCP205-16 Bearing
  • Type: Pillow Block Mounted Bearing
  • Bolt Size: 3/8" inch
  • Basic Dynamic Load (Cr): 14 KN
  • Basic Static Load (Cor): 7.85 KN
  • Bearing No: UC205-16
  • Housing No: P205
  • Quantity: One Bearing


Dimensions (Inches)
h a e b S2 S1 g W B1 n
1-7/16" 5-1/2" 4-1/8" 1-1/2" 3/4" 1/2" 1/2" 2-25/32" 1.339" 0.563"



1" Bearing UCP205-16 + Pillow Block Cast Housing Mounted Bearings


Kit7369


Average Rating: 5 of 5 Total Reviews: 9 Write a review »

  0 of 0 people found the following review helpful:
 
Q;uality appears first-rate. January 27, 2015
Reviewer: John Buck  
I will use the bearings on a drum sander that I am constructing.  With a one-inch shaft and these bearings the drum will be well supported and should run with little or no vibration.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Great service and Price September 1, 2014
Reviewer: John  
Great company service

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
Great bargain for the price! February 9, 2014
Reviewer: The Woodworking Wizard from La Grange, NY  
I purchased a set of these bearings to support the drum shaft of my shop-built sanding drum. I priced similar bearings that were 6 times the cost of these. However  you do get what you pay for. The cast iron housing wasn't machined very well and I was forced to shim the housing block and had to offset the housing perpendicular to the shaft to get the shaft to run true. But  for the price  I think it's a good bargain. It did the job and seems to work well. Hopefully the bearing itself will hold up under constant use.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
I would buy this product again. November 21, 2013
Reviewer: Johnnie De  
I use the two bearings for the drum sander I built. It works great.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
fantastic March 5, 2013
Reviewer: hot-d-dog  
great

Was this review helpful to you?

View All Customer Reviews